Read Diagnostic Trouble Code (DTC): Operation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
When malfunction of airbag system occurs, the DTC stored in airbag control module will be read out.
- On the «Main Menu», select {Each System Check}.
- On the «System Selection Menu», select {Airbag System}.
- After {Airbag System} is displayed, select [OK].
- Select the {Diagnostic Code(s) Display} in «Airbag System».
- Record the DTC displayed.
NOTE:
- For details concerning the operation procedure, refer to the "PC application help for Subaru Select Monitor".
- For details concerning DTCs, refer to "List of Diagnostic Trouble Code (DTC)". < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >
- If "No diagnostic Code Present" is displayed, the combination meter fault or the open circuit of harness is possible. For the diagnostic procedure, refer to < Refer to AIRBAG WARNING LIGHT FAILURE . >.
- When the airbag warning light is OFF and "No diagnostic Code Present" is displayed on Subaru Select Monitor, the airbag system is operating properly.