LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 56 (Seat Belt System) >> Front Seat Belt >> Removal >> Inner Seat Belt Assembly

Inner Seat Belt Assembly

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 60 seconds or more.
    NOTE: For the power seat, remove the slide rail installing bolt before removing the battery ground.
  2. Remove the slide rail installing bolt.
    1. Tilt the backrest forward and move the seat to the front most position.
    2. Remove the rear bolt cover at the rear side of the slide rail and remove the bolt.
    3. Move the seat to the rearmost position, and remove the bolt on the front side of the slide rail.
  3. Disconnect the seat belt warning light connector under the seat.
  4. Remove the harness clips from seat cushion frame.
  5. Remove the bolts, then remove the inner seat belt assembly.
    Fig 1: Identifying Inner Seat Belt Assembly Mounting Bolt
    G05957665Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals