HYPOID Driven Gear RUNOUT On Its Back Surface

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Using a dial gauge, check the hypoid driven gear back surface runout.

Hypoid driven gear back surface runout:

0.05 mm (0.002 in)

If the hypoid driven gear runout exceeds specification, replace the hypoid driven gear.

Fig 1: Measuring Hypoid Driven Gear Back Surface Runout Using Dial Gauge

Courtesy of SUBARU OF AMERICA, INC.