Wheel Balancing

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Using the wheel balancer, measure wheel balance.
Adjust the wheel balancing.

NOTE:

Unbalance after adjusting the wheel balancing should be 5 g (0.18 oz) or less.
When using the adhesive type weight, degrease the surface where the adhesive type weight will be applied securely.
After applying the adhesive type weight, apply a force to the weight and attain full adhesion.
Using the knock-on type weight, check the size of the knock-on part.

Fig 1: Identifying Knock-On Type Weight (For Aluminum And Steel Wheel)

Courtesy of SUBARU OF AMERICA, INC.

Service limit A:

Knock-on type weight for steel wheel: 2.0 mm (0.079 in)

Knock-on type weight for aluminum wheel: 5.0 mm (0.197 in)