Enable Conditions
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
ENABLE CONDITION
| Secondary Parameters | Enable Conditions |
|---|---|
| Battery voltage | > 10.9 V |
| Atmospheric pressure | > 75 kPa (563 mmHg, 22.2 inHg) |
| A/F main learning system | In operation |
| Engine speed | > 450 rpm |
| Engine coolant temperature | > 70 °C (158 °F) |
| Intake air temperature | < 70 °C (158 °F) |
| Engine load | > Value of Map 1 |
| Engine load change | < 0.02 g/rev (0 oz/rev) |
| Evaporative system leak check | Not in operation |
| Cumulative time of canister purge after engine start | ≥ 20 s |
| Learning value of EVAP conc. | < 0.2 |
| Vehicle dynamic control or AT torque control | Not in operation |
| Intake manifold pressure change at 180°CA | < Value of Map 2 |
| Throttle position change during 16 milliseconds | < 14 ° |
| Fuel shut-off function | Not in operation |
MAP 1
| Engine speed (rpm) | Idling | 800 | 1200 | 1600 | 2000 | 2400 | 2800 | 3200 | 3600 | 4000 | 4400 |
| Measured value (g (oz)/rev) | na | 0.228 (0.01) | 0.22 (0.01) | 0.22 (0.01) | 0.22 (0.01) | 0.228 (0.01) | 0.23 (0.01) | 0.234 (0.01) | 0.242 (0.01) | 0.25 (0.01) | 0.25 (0.01) |
MAP 2
| rpm | 700 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 | 4000 | 4500 | 5000 | 5500 | 6000 | 6500 | 6700 |
| kPa (mmHg, inHg) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) | 26.7 (200, 7.9) |