LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Diagnostic Trouble Code (DTC) Detecting Criteria (H4DOTC)) >> Diagnostic Trouble Code (DTC) Detecting Criteria >> DTC P0410 Secondary Air Injection System >> Combination Valve Both Closed Pulse Diagnosis

Combination Valve Both Closed Pulse Diagnosis

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Perform open stuck diagnosis of both combination valves using delivery pipe pressure pulse when both combination valves are closed.

Determine which side of valves is stuck open by comparing secondary air flow amount when RH combination valve is closed with that when LH combination valve is closed. Calculate voltage pulse of the pump delivery pipe pressure when both combination valves are closed. The calculation should be small because there is no pulse from supply pipe pressure with both combination valves closed. When the calculation is large, determine that either of the combination valves is stuck open. Determine which side of valves is stuck open by comparing secondary air flow amount when the RH combination valve is closed with that when the LH combination valve is closed. Air flow amount is larger on the open stuck valve.

If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.

JUDGMENT VALUE

Malfunction Criteria Threshold Value DTC
Pulse calculation value when both combination valves are closed > Value of Map 3 P2440
Air flow amount when the right bank is closed (value from Map 4) ≥ Air flow amount when the left bank is closed (value from Map 5)  
Pulse calculation value when both combination valves are closed > Value of Map 3 P2442
Air flow amount when the left bank is closed (value from Map 5) > Air flow amount when the right bank is closed (value from Map 4)  

Time Needed for Diagnosis:  4000 ms + 992 ms + 992 ms + 992 ms

Malfunction Indicator Light Illumination:  Illuminates when malfunction occurs in 2 continuous driving cycles.

Judge as OK and clear the NG if the continuous time while the following conditions are established is more than the predetermined time.

JUDGMENT VALUE

Malfunction Criteria Threshold Value DTC
Pulse calculation value when both combination valves are closed ≤ Value of Map 3 P2440, P2442

Time Needed for Diagnosis:  4000 ms + 992 ms + 992 ms + 992 ms