LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Diagnostic Trouble Code (DTC) Detecting Criteria (H4DOTC)) >> Diagnostic Trouble Code (DTC) Detecting Criteria >> DTC P0125 Insufficient Coolant Temperature For Closed Loop Fuel Control >> Diagnostic Method

Diagnostic Method

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Judge as NG if the criteria below are met.

JUDGMENT VALUE

Malfunction Criteria Threshold Value
Engine coolant temperature < 20 °C (68 °F)
Timer for diagnosis after engine start ≥ Judgment value of timer after engine start

Timer for diagnosis after engine start

  1. Timer stop at fuel cut
  2. During the driving conditions except a) above, timer counts up as follows.

64 ms + TWCNT ms (when at 64 ms)

TWCNT is defined as follows,

TWCNT = 0 at idle switch ON,

TWCNT show on the following table at idle switch OFF.

  Vehicle speed km/h (MPH)
0 (0) 8 (5) 16 (9.9) 24 (14.9) 32 (19.9) 40 (24.9) 48 (29.8) 56 (34.8)
Temperature °C (°F) -20 (-4) 0 ms 37.136 ms 74.272 ms 111.41 ms 126.66 ms 141.91 ms 163.59 ms 185.26 ms
-10 (14) 0 ms 27.391 ms 54.782 ms 82.173 ms 99.65 ms 117.13 ms 135.96 ms 154.8 ms
0 (32) 0 ms 17.646 ms 35.292 ms 52.938 ms 72.64 ms 92.341 ms 108.34 ms 124.33 ms
10 (50) 0 ms 7.9012 ms 15.802 ms 23.704 ms 45.63 ms 67.556 ms 80.711 ms 93.867 ms
20 (68) 0 ms 7.9012 ms 15.802 ms 23.704 ms 45.63 ms 67.556 ms 80.711 ms 93.867 ms

Judgment value of timer after engine starting

t = 451056 ms - 25870 ms x Ti

Ti : The lowest coolant temperature after engine start

Time Needed for Diagnosis:  Less than 1 second

Malfunction Indicator Light Illumination:  Illuminates when malfunction occurs in 2 continuous driving cycles.

Judge as OK and clear the NG when the malfunction criteria below are met.

JUDGMENT VALUE

Malfunction Criteria Threshold Value
Engine coolant temperature ≥ 20 °C (68 °F)

Time Needed for Diagnosis:  Less than 1 second