Oil Pump: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Using the ST, install the front oil seal.
ST 499587100 OIL SEAL INSTALLER

NOTE:
Use a new front oil seal.

Fig 1: Installing Front Oil Seal Using Oil Seal Installer
Courtesy of SUBARU OF AMERICA, INC.
Apply liquid gasket to the mating surfaces of oil pump.
NOTE:
Install within 5 min. after applying liquid gasket.

Liquid gasket:

THREE BOND 1217G (Part No. K0877Y0100) or equivalent

Fig 2: Identifying Liquid Gasket Applying Areas On Mating Surfaces Of Oil Pump
Courtesy of SUBARU OF AMERICA, INC.
Apply a coat of engine oil to the inside of front oil seal.

Fig 3: Identifying Engine Oil Applying Areas On Inside Of Front Oil Seal
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pump to cylinder block.
CAUTION:
- Be careful not to damage the front oil seal during installation.
- Make sure the front oil seal lip is not folded.
NOTE:
- Align the flat surface of oil pump's inner rotor with that of crankshaft before installation.
- Use new O-rings.
- Do not forget to assemble O-rings.
Apply liquid gasket to the three bolts thread shown in figure. (when reusing bolts)
Liquid gasket:

THREE BOND 1324 (Part No. 004403042) or equivalent

Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 4: Applying Liquid Gasket To Three Bolts Thread
Courtesy of SUBARU OF AMERICA, INC.
Install the crank sprocket. < Refer to INSTALLATION , Crank Sprocket. >
Install the water pump. < Refer to INSTALLATION , Water Pump. >
Install the crankshaft position sensor. < Refer to INSTALLATION , Crankshaft Position Sensor. >
Install the radiator. < Refer to INSTALLATION , Radiator. >
Connect the battery ground terminal.

Fig 5: Connecting Ground Cable From Battery
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.