Section 46 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC)): Canister: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while being careful of the following.
- Connect the quick connector as shown in the figure.
CAUTION:
- Check that there is no damage or dust on the quick connector. If necessary, clean the seal surface of the pipe.
- When connecting the quick connector, securely insert the pipe all the way before locking the retainer.
- When it is difficult to lock the retainer, make sure that the pipe is securely inserted.
- Make sure that the quick connector is securely connected.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
Tightening torque:
8 N.m (0.8 kgf-m, 5.9 ft-lb)
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)