Back-Up Light And Neutral Position Switch

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground cable from battery.
Remove the air intake boot. < Refer to REMOVAL , Air Intake Boot. >
Disconnect the connector back-up light switch & neutral position switch.

Fig 1: Identifying Neutral Position Switch Connector (Brown) And Back-Up Light Switch Connector (gray)
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Remove the back-up light switch & neutral position switch with the harness.

Fig 2: Identifying Neutral Position Switch And Back-Up Light Switch
Courtesy of SUBARU OF AMERICA, INC.