Reverse Check Sleeve: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the reverse check sleeve assembly.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 1: Identifying Reverse Check Sleeve Assembly
Courtesy of SUBARU OF AMERICA, INC.
Install the ball, reverse accent spring, gasket and plug to the transfer case.
NOTE: Use a new gasket.

Tightening torque:

9.75 N.m (1.0 kgf-m, 7.2 ft-lb)

Fig 2: Identifying Plug, Gasket, Reverse Accent Spring, And Reverse Check Ball
Courtesy of SUBARU OF AMERICA, INC.
Attach the shifter arm to the transfer case assembly.
Install the transfer case together with the extension case assembly. < Refer to INSTALLATION , Transfer Case and Extension Case Assembly. >
Install the manual transmission assembly to the vehicle. < Refer to INSTALLATION , Manual Transmission Assembly. >