Roll Connector: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Turn the ignition switch to OFF.
Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.
Remove the driver's airbag module. < Refer to DRIVER'S AIRBAG MODULE . >
Remove the steering wheel. < Refer to REMOVAL , Steering Wheel. >
Remove the steering column cover.
Remove the screws, and then remove the roll connector.

Fig 1: Identifying Roll Connector And Mounting Screws
Courtesy of SUBARU OF AMERICA, INC.