LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Anti-Theft System - Security And Locks) >> Front Door Latch and Door Lock Actuator Assembly >> Removal

Front Door Latch and Door Lock Actuator Assembly: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the front door glass to the top position.
  2. Disconnect the ground cable from battery.
  3. Remove the front door trim. < Refer to FRONT DOOR , REMOVAL, Door Trim. >
  4. Remove the sealing cover. < Refer to REMOVAL , Front Sealing Cover. >
  5. Remove the glass run rubber (A) partially.
    Fig 1: Identifying Glass Run Rubber
    G05957949Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the bolts, and then remove the door sash.
  7. Remove the rod from the outer handle rod clamp.
  8. Disconnect the harness connector of front door latch and door lock actuator assembly.
  9. Remove the screws, and remove the front door latch & door lock actuator assembly.
    Fig 2: Locating Screws Of Front Door Latch And Door Lock Actuator Assembly
    G05663684Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals