Rear Door: Adjustment

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Open the rear door, loosen the door-side bolts of upper and lower hinges to align the position for vertical and horizontal direction of rear door panel.

Fig 1: Removing Front Door Panel
Courtesy of SUBARU OF AMERICA, INC.
Loosen the screw (A) and tap striker (B) using plastic hammer to adjust the gap between rear end surface of rear door panel and body surface.
CAUTION: Do not use an impact wrench. Welding area on the striker nut plate is easily broken.

Fig 2: Identifying Striker And Screws
Courtesy of SUBARU OF AMERICA, INC.