Front Hood: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install each part in the reverse order of removal.

NOTE:

Be careful not to catch the window washer hose between insulators etc.
Install while paying attention to make a uniform clearance around the front hood panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description".< Refer to SPECIFICATION , General Description. >

Tightening torque:

Refer to "COMPONENT" of "General Description".< Refer to FRONT HOOD , COMPONENT, General Description. >