Front Fender: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Always use new double sided tape.
- After the installation of front fender panel, be sure to perform headlight beam adjustment.
- Install each part in the reverse order of removal.
Tightening torque:
7.5 N.m (0.76 kgf-m, 5.5 ft-lb)
NOTE: Install while paying attention to make a uniform clearance around the front fender panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description".< Refer to SPECIFICATION , General Description. > - Adjust the headlight beam and fog light beam.
- Adjust the headlight beam.< Refer to HEADLIGHT BEAM ADJUSTMENT , ADJUSTMENT, Headlight Assembly. >
- Adjust the fog light beam. (Model with fog light)< Refer to FOG LIGHT AIMING , ADJUSTMENT, Front Fog Light Assembly. >