Front Door: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Put a wooden block on jack and place the front door on that.
- Apply grease to the sliding area of door hinges, and install the door hinge to vehicle.
- Install the front door to upper hinge and lower hinge adjusting by jack.
- Tighten bolt of door checker.
- Connect door harness connector, and install the instrument panel lower cover.
- Install the front pillar lower trim.
Tightening torque:
Refer to "COMPONENT" of "General Description".< Refer to REAR DOOR , COMPONENT, General Description. >
- Install while paying attention to make a uniform clearance around the front door panel. For the dimension of clearance, refer to "SPECIFICATION" in "General Description".< Refer to SPECIFICATION , General Description. >