LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Exterior Body Panels) >> Door Sash Tape >> Removal >> Front Door

Front Door

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the front door trim.< Refer to FRONT DOOR , REMOVAL, Door Trim. >
  3. Remove the outer mirror assembly.< Refer to REMOVAL , Outer Mirror Assembly. >
  4. Remove the sealing cover.< Refer to REMOVAL , Front Sealing Cover. >
  5. Remove the front door glass.< Refer to REMOVAL , Front Door Glass. >
  6. Remove the glass run rubber.
  7. Remove the B pillar upper clip, and remove the front door weather strip.
    Fig 1: Identifying B Pillar Upper Clip
    G05958192Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the screws, and remove the front door weather strip outer.
    CAUTION:
    • When removing the weather strip outer, be careful not to damage the vehicle.
    • If the weather strip outer is deformed, always replace with a new part.
    Fig 2: Locating Front Door Weather Strip Outer Screw
    G05958193Courtesy of SUBARU OF AMERICA, INC.
  9. Peel the door sash tape from the door sash.
    NOTE:
    • If the tape is difficult to remove, warm the tape with a hairdryer, etc. to make the removal easier.

      Use a household hairdryer. Do not use industrial dryers.

    • If tape residue is remaining on the door sash, wipe clean.