LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (LAN Communication System (Diagnostics)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC U1223 Can-HS VDC/Abs No-Receive Data >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK DTC. 
Read all DTCs using the Subaru Select Monitor.< Refer to OPERATION , Subaru Select Monitor. >		 Is there DTC U1202? Perform the diagnosis according to DTC. Go to step 2  .
2 CHECK DTC. 
Read the DTC of body integrated unit using Subaru Select Monitor.		 Is U1223 a current malfunction? Go to step 3  . Go to step 7  .
3 CHECK DTC. 
  1. Turn the ignition switch to OFF.
  2. Disconnect all control module connectors (B280, B310, B55, B136, B230, B231) that are connected to high speed CAN communication line.
  3. Connect the disconnected connectors.
  4. Turn the ignition switch to ON.
  5. Read the DTC of body integrated unit using Subaru Select Monitor.
 Is U1223 a current malfunction? Go to step 4  . Go to step 7  .
4 CHECK HARNESS. 
  1. Turn the ignition switch to OFF.
  2. Disconnect all control module connectors (B280, B310, B55, B136, B230, B231) that are connected to high speed CAN communication line.
  3. Using the tester, check for open, short (power supply-output short, GND-output short) in the harness.

    Connector & terminal 

    (B40) No. 6 - (B310) No. 35: 

    (B40) No. 14 - (B310) No. 10: 

 Is harness normal? Go to step 5  . Repair or replace the harness.
5 CHECK DTC. 
  1. Connect the disconnected connectors.
  2. Start the engine and stop.
  3. Turn the ignition switch to ON.
  4. Read the DTC of body integrated unit using Subaru Select Monitor.
 Is U1223 a current malfunction? Go to step 6  . Go to step 7  .
6 CHECK DTC. 
Read all DTCs using the Subaru Select Monitor.		 Is P1718 or U0122 displayed? Replace the VDC/ABS CM.< Refer to REMOVAL , VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). > Replace the body integrated unit.< Refer to REMOVAL , Body Integrated Unit. >
7 CHECK HARNESS. 
  1. Turn the ignition switch to OFF.
  2. Shake the harness used for CAN communication circuit.
  3. Turn the ignition switch to ON.
  4. Read the DTC of body integrated unit using Subaru Select Monitor.
 Is U1223 a current malfunction? Repair or replace the harness. Go to step 8  .
8 CHECK CONNECTOR. 
  1. Turn the ignition switch to OFF.
  2. Disconnect all control module connectors (B280, B310, B55, B136, B230, B231) that are connected to high speed CAN communication line.
 Is there connector terminal where poor contact exists? Repair the connector terminal where poor contact exists, or replace harness. Temporary poor contact occurs.
scientia non olet · About LEMON Manuals