Abs Warning Light Does Not Go Off: Trouble Symptom
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
When starting the engine, the ABS warning light and hill start assist warning light are kept ON.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 READ DTC. Read the DTC. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . > |
Is DTC displayed? | Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > | Go to step 2 . |
| 2 CHECK LAN SYSTEM. Perform the diagnosis for LAN system. < Refer to BASIC DIAGNOSTIC PROCEDURE . > |
Is there any fault in LAN system? | Perform the diagnosis according to DTC for LAN system. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > | Go to step 3 . |
| 3 CHECK COMBINATION METER. Check the combination meter. < Refer to INSPECTION , Combination Meter System. > |
Is combination meter OK? | Replace the VDCCM only. < Refer to REPLACEMENT , VDC Control Module and Hydraulic Control Unit (VDCCM&H/U). > | Replace the combination meter. < Refer to COMBINATION METER . > |