Fuel Pump Circuit
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
After servicing or replacing faulty parts, perform Clear Memory Mode < Refer to
OPERATION , Clear Memory Mode. >, and Inspection Mode < Refer to
PROCEDURE , Inspection Mode. >.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK OPERATING SOUND OF FUEL PUMP. Make sure that the fuel pump operates for two seconds when turning the ignition switch to ON.
NOTE:
Fuel pump operation can be executed using the Subaru Select Monitor.
For the procedures, refer to "Compulsory Valve Operation Check Mode". < Refer to COMPULSORY VALVE OPERATION CHECK MODE . > |
Does the fuel pump emit operating sound? | Check the fuel injector circuit. < Refer to FUEL INJECTOR CIRCUIT , Diagnostics for Engine Starting Failure. > | Display the DTC. < Refer to OPERATION , Read Diagnostic Trouble Code (DTC). > |