Diagnostic Procedure
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
| 1 CHECK CONDITION OF CRANKSHAFT POSITION SENSOR. Turn the ignition switch to OFF. |
Is the crankshaft position sensor installation bolt tightened securely? | Go to step 2. | Tighten the crankshaft position sensor installation bolt securely. < Refer to CRANKSHAFT POSITION SENSOR . > |
| 2 CHECK CRANK SPROCKET. Remove the timing belt cover. |
Are crank sprocket teeth cracked or damaged? | Replace the crank sprocket. < Refer to CRANK SPROCKET . > | Go to step 3. |
| 3 CHECK INSTALLATION CONDITION OF TIMING BELT. Turn the crankshaft, and align alignment mark on crank sprocket with alignment mark on cylinder block. ST 499987500 CRANKSHAFT SOCKET |
Is the timing belt dislocated from its proper position? | Repair the installation condition of timing belt. < Refer to TIMING BELT . > | Replace the crankshaft position sensor. < Refer to CRANKSHAFT POSITION SENSOR . > |