LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Instrumentation System & Driver Information Center) >> Clock System >> Inspection >> Check Power Supply And Ground Circuit

Check Power Supply And Ground Circuit

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Step Check Yes No
1 CHECK POWER SUPPLY. 
  1. Disconnect the clock connector.
  2. Measure the voltage between clock connector and chassis ground.

    Connector & terminal 

    (i59) No. 10 (+) - Chassis ground (-): 

 Is the voltage 10 V or more? Go to step 2  . Check the harness for a open or short between the fuse and clock.
2 CHECK GROUND CIRCUIT. 
Measure the resistance between the clock connector and chassis ground.
Connector & terminal 
(i59) No. 6 - Chassis ground: 		 Is the resistance less than 10 Ω? Go to step 3  . Repair or replace the harness.
3 CHECK HARNESS BETWEEN CLOCK AND COMBINATION METER. 
  1. Disconnect the combination meter connector.
  2. Measure the resistance between the clock connector and combination meter connector.

    Connector & terminal 

    (i59) No. 5 - (i10) No. 29: 

 Is the resistance less than 10 Ω? Go to step 4  . Repair or replace the harness.
4 CHECK CLOCK. 
  1. Remove the clock.
  2. Attach the clock to another vehicle on which the clock operates normally to check its operation.
 Is clock normal? Replace the meter case assembly. Replace the clock body.
scientia non olet · About LEMON Manuals