LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (General Information) >> Pre-delivery Inspection >> Pre-Delivery Inspection (PDI) Procedure >> Towing Hook (Eyebolt)

Towing Hook (Eyebolt)

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: At factory shipment, the towing hook (eyebolt) is installed to the rear bumper for securing the vehicle during transportation. Follow the procedure below to store the towing hook (eyebolt) to the holder in the spare tire.
  1. Remove the towing hook (eyebolt) from the rear bumper.
    Fig 1: Identifying Towing Hook (Eyebolt)
    G08569970Courtesy of SUBARU OF AMERICA, INC.
  2. Store the towing hook (eyebolt) to the holder in the spare tire.
    Fig 2: Identifying Spare Tire, Holder And Towing Hook (Eyebolt)
    G08569971Courtesy of SUBARU OF AMERICA, INC.
  3. Install the supplied rear hook cover to rear bumper.
    Fig 3: Identifying Rear Hook Cover
    G08569972Courtesy of SUBARU OF AMERICA, INC.