LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Seat System - Seats) >> Rear Seat >> Disassembly

Rear Seat: Disassembly

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat. < Refer to REMOVAL , Rear Seat. >
  2. Remove the armrest hinge cover in the direction of the black arrow, and remove the screws to remove the armrest.
    Fig 1: Removing Armrest Hinge Cover
    G05663664Courtesy of SUBARU OF AMERICA, INC.
    NOTE: The armrests cannot be detached while the backrest assembly RH and armrest side pin positions are not aligned.
    Fig 2: Identifying Armrest Side Pin Positions
    G05663665Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the backrest knob. (Screw-in type)
    Fig 3: Identifying Backrest Knob (Screw-In Type)
    G05663666Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the seat backrest latch cover.
    Fig 4: Identifying Seat Backrest Latch Cover
    G05663667Courtesy of SUBARU OF AMERICA, INC.
  5. Peel back the backrest cover and remove the hog rings.
    Fig 5: Identifying Hog Rings On Backrest Cover
    G05663668Courtesy of SUBARU OF AMERICA, INC.
  6. Remove all the hog rings securing the backrest frame and backrest pad.
  7. Remove the headrest bushing.
  8. Remove the backrest pad and backrest cover from the backrest frame.
  9. Disassemble the backrest assembly LH by referring to above procedures.
  10. Remove the bolts on the backside of the seat cushion, and remove the seat table assembly.
    Fig 6: Locating Bolts On Backside Of Seat Cushion
    G05957927Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the bolts on the right and left sides, and remove the seat table assembly.
    Fig 7: Locating Seat Table Assembly Bolts
    G05957928Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolts and the seat table hinge.
    Fig 8: Locating Seat Table Hinge Bolts
    G05957929Courtesy of SUBARU OF AMERICA, INC.
  13. Remove the hooks and the seat table plate.
    Fig 9: Identifying Hooks And Seat Table Plate
    G05957930Courtesy of SUBARU OF AMERICA, INC.
  14. Remove all the hog rings on the backside of the seat cushion, and disassemble the seat cushion cover and seat cushion pad.
  15. Detach the plastic zipper and hog ring, and then remove the armrest cover.
    Fig 10: Identifying Armrest Cover
    G05022779Courtesy of SUBARU OF AMERICA, INC.