LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Seat System - Seats) >> Front Seat >> Removal >> Driver's Seat

Driver's Seat

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery, and wait for 60 seconds or more before starting work.
    NOTE: Remove the front and rear bolts from the slide rail of the power seat before removing the battery ground.
  2. Remove the headrest.
  3. Remove the slide rail installing bolt.
    1. Tilt the backrest forward and move the seat to the front most position.
    2. Remove the rear bolt cover at the rear side of the slide rail and remove the bolt.
    3. Move the seat to the rearmost position, and remove the bolt on the front side of the slide rail.
  4. Disconnect the connector under the seat.
    • Seat belt warning light connector (driver's seat)
    • Side airbag connector
    • Seat heater connector (model with seat heater)
    • Power seat connector (model with power seats)
  5. Remove the front seat from vehicle.
scientia non olet · About LEMON Manuals