PCV Hose Assembly: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Attach the PCV hose assembly to the PCV connector.

Fig 1: Locating PCV Hose Assembly Clip
Courtesy of SUBARU OF AMERICA, INC.
Install the PCV hose assembly onto the cylinder block RH and cylinder block LH.
NOTE: Use a new clamp for the PCV hose assembly, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 2: Locking Clamp Using Clamp Pliers
Courtesy of SUBARU OF AMERICA, INC.
Install the tumble generator valve assembly. < Refer to INSTALLATION , Tumble Generator Valve Assembly. >
Install the intake manifold. < Refer to INSTALLATION , Intake Manifold. >