Malfunction Indicator Light Does Not Blink: Wiring Diagram
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
Engine electrical system, non-turbo model < Refer to appropriate SYSTEM WIRING DIAGRAM. >
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK STATUS OF MALFUNCTION INDICATOR LIGHT.
|
Does the malfunction indicator light illuminate? | Go to step 2 . | Repair the malfunction indicator light circuit. < Refer to MALFUNCTION INDICATOR LIGHT DOES NOT COME ON , Malfunction Indicator Light. > |
| 2 CHECK VEHICLE SPECIFICATION. | Is the vehicle except for C6 model? | Go to step 4 . | Go to step 3 . |
3 CHECK HARNESS BETWEEN ECM AND COMBINATION METER CONNECTOR.
|
Does the malfunction indicator light illuminate? | Repair the ground short circuit of harness between ECM and combination meter connector. | Go to step 4 . |
4 CHECK HARNESS BETWEEN ECM AND DELIVERY (TEST) MODE CONNECTOR.
|
Is the resistance less than 1 Ω? | Go to step 5 . | Repair the harness and connector.
NOTE:
In this case, repair the following item:
|
| 5 CHECK FOR POOR CONTACT. Check for poor contact of ECM connector. |
Is there poor contact of ECM connector? | Repair the poor contact of ECM connector. | Replace the ECM. < Refer to ENGINE CONTROL MODULE (ECM) . > |