DTC P0032 Ho2S Heater Control Circuit High (Bank 1 Sensor 1): Wiring Diagram

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Engine electrical system, non-turbo model < Refer to appropriate SYSTEM WIRING DIAGRAM. >

Fig 1: HO2S Heater Control Circuit High - Wiring Diagram (Bank 1 Sensor 1)

Courtesy of SUBARU OF AMERICA, INC.

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND FRONT OXYGEN (A/F) SENSOR CONNECTOR. Turn the ignition switch to OFF. Measure the voltage between ECM and chassis ground. Connector & terminal (B136) No. 5 (+) - Chassis ground (-): (B136) No. 6 (+) - Chassis ground (-):	Is the voltage 10 V or more?	Repair the short circuit to power in the harness between ECM and front oxygen (A/F) sensor connector.	Go to step 2 .
2 CHECK GROUND CIRCUIT FOR ECM. Disconnect the connector from ECM. Measure the resistance between ECM and chassis ground. Connector & terminal (B134) No. 3 - Chassis ground: (B134) No. 4 - Chassis ground: (B134) No. 6 - Chassis ground: (B137) No. 1 - Chassis ground: (B137) No. 3 - Chassis ground:	Is the resistance less than 5 Ω?	Repair the poor contact of ECM connector.	Repair the harness and connector. NOTE: In this case, repair the following item: Open circuit of harness between ECM and engine ground Poor contact of coupling connector