LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Exterior Trim & Interior Trim) >> 9. Cowl Panel >> A: Removal

A: Removal

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the front hood.
  2. Remove the wiper arm. < Refer to REMOVAL , Front Wiper Arm. >
  3. Detach the tabs and remove the cowl panel, side.
    Fig 1: Cowl Side Panel Front And Tabs
    G07680527Courtesy of SUBARU OF AMERICA, INC.
    1. Detach tabs (A), (B), and (C) from the vehicle exterior.
    2. Detach tabs (D) and (E).
  4. Pull out and disconnect the washer hose.
    Fig 2: Identifying Washer Hose
    G05958049Courtesy of SUBARU OF AMERICA, INC.
  5. Remove clips (A) and (B), and remove the cowl panel.
    Fig 3: Locating Cowl Panel Clips
    G05958050Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Press on the clip tabs from the left and right when removing clips (B).
    Do not pull forcibly on the clips to prevent damaging them.
    Fig 4: Pushing Claws Of Clips
    G05663774Courtesy of SUBARU OF AMERICA, INC.
  6. Disconnect the washer hose.
  7. Remove the washer nozzle. < Refer to REMOVAL , Front Washer Nozzle. >