1. Coating Method For Pp Bumper
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
| Process No. | Process name | Job contents | |
|---|---|---|---|
| 1 | Bumper installation | Place the bumper on a paint worktable as required. Use the paint worktable conforming to inner shape of bumper if possible. | |
| 2 | Masking | Mask specified part (black base) with masking tape. Use masking tape for PP. | |
| 3 | Degreasing/cleaning | Clean all parts to be painted with white gasoline, normal alcohol, etc. to remove dirt, oil, fat, etc. | |
| 4 | Primer paint | Apply primer to all parts to be painted, using spray gun. Use primer (clear). | |
| 5 | Drying | Dry at normal temperature [10 to 15 min. at 20°C (68°F)]. In half-dried condition, PP primer paint is dissolved by solvent, e.g. thinner, etc. Therefore, if dust or dirt must be removed, use ordinary alcohol etc. |
|
| 6 | Top coat paint (I) | Non-colored | Metallic paint |
| Use section (block) paint for top coat. For paint/hardener mixture, observe the specifications recommended by the manufacturers.
|
Use section (block) paint for top coat. For paint/hardener mixture, observe the specifications recommended by the manufacturers.
|
||
| 7 | Drying | Not required. | Dry at normal temperature [at least 10 min. at 20°C (68°F)]. In half-dried condition, avoid dust, dirt. |
| 8 | Top coat paint (II) | Not required. | Apply a clear coat to parts with top coat paint (I), three times at 5 - 7 minute intervals. For paint/hardener mixture, observe the specifications recommended by the manufacturers.
|
| 9 | Drying | 60°C (140°F), 60 min. or 80°C (176°F), 30 min. If the temperature is higher than 80°C (176°F), PP may be deformed. Keep maximum temperature at 80°C (176°F) or less. |
|
| 10 | Inspection | Check paint. | |
| 11 | Removal of masking | Remove the masking tape applied in procedure 2. | |