LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Exterior Trim & Interior Trim) >> 7. Front Bumper >> A: Removal >> 1. Front Bumper Face

1. Front Bumper Face

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
  2. Remove the clips at the upper side of the bumper.
    Fig 1: Locating Clips At Upper Side Of Bumper
    G05958029Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the clips from the fender.
    Fig 2: Locating Fender Clips
    G05958030Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the clips at the lower side of bumper.
    Fig 3: Locating Clips At Lower Side Of Bumper
    G05958031Courtesy of SUBARU OF AMERICA, INC.
  5. Disconnect the fog light connector. (Model with fog light)
  6. Detach the flange section on the bumper face side from the front side bracket.
    CAUTION: Do not pull forcibly. It may damage the flange sections of the bumper face.
    NOTE: It is easier to detach them from the fender side in the order from (1) to (3), while pulling up the bumper face to the direction of arrow (upward).
    Fig 4: Pulling Up Bumper Face
    G05958032Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the bumper face from vehicle body.
  8. Remove the front grille from bumper face. < Refer to REMOVAL , Front Grille. >
  9. Remove the fog light from bumper face. < Refer to REMOVAL , Front Fog Light Assembly. >
scientia non olet · About LEMON Manuals