B: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the roof carrier bracket.
Tightening torque:

7.5 N.m (7.6 kgf-m, 5.5 ft-lb)
Remove the clips from the roof molding, and attach to the studs on the vehicle.
CAUTION: Always replace clips that were damaged during removal of the roof molding.
Push the front end of the roof molding against the front window, and attach the forward positioning clip onto the rivet on the body.

Fig 1: Identifying Windshield, Positioning Clip, Roof Molding, Rivet And Clip
Courtesy of SUBARU OF AMERICA, INC.
While pushing down on the roof molding from above, join the roof molding and clips.