Unit Inspection

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Preparation tool: Circuit tester

Check the resistance between in-vehicle sensor terminals.

CAUTION: During inspection, be careful not to touch the sensor end in order to avoid misjudgment due to body temperature.

Fig 1: Checking Resistance Between In-Vehicle Sensor Terminals

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
1 - 2	10°C	3.772 - 4.101 kΩ
	15°C	3.096 - 3.338 kΩ
	20°C	2.556 - 2.734 kΩ
	25°C	2.121 - 2.251 kΩ
	30°C	1.756 - 1.878 kΩ
	35°C	1.462 - 1.574 kΩ
	40°C	1.223 - 1.326 kΩ
	45°C	1.028 - 1.122 kΩ
	50°C	0.868 - 09542 kΩ
	55°C	0.7363 - 0.8147 kΩ
	60°C	0.6273 - 0.6984 kΩ

Replace the in-vehicle sensor if the inspection result is not within the standard value.