Propeller Shaft: Installation
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the sleeve yoke into the transmission and attach center bearing to body.
Courtesy of SUBARU OF AMERICA, INC.
Tightening torque:
52 N.m (5.30 kgf-m, 38.3 ft-lb)
- Align the alignment marks (A), and connect the flange yoke and rear differential.
Courtesy of SUBARU OF AMERICA, INC.
Tightening torque:
31 N.m (3.16 kgf-m, 22.9 ft-lb)
- Install the heat shield cover.
- Install the center exhaust pipe.
- Install the rear exhaust pipe and muffler.
- Lower the vehicle.
- Connect the battery ground terminal.