Front Lateral Link: Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to use a new self-locking nut.
Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.

Install each part in the reverse order of removal.
Tightening torque:

Front lateral link - Sub frame

100 N.m (10.20 kgf-m, 73.8 ft-lb)

Front lateral link - Rear axle housing

60 N.m (6.12 kgf-m, 44.3 ft-lb)
Inspect the wheel alignment and adjust if necessary. < Refer to INSPECTION , Wheel Alignment. >