Transmission Rear CROSSMEMBER And Rear Cushion Rubber
WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear cushion rubber.
Tightening torque:
40 N.m (4.1 kgf-m, 29.5 ft-lb)
- Install the transmission rear crossmember.
Tightening torque:
T1: 35 N.m (3.6 kgf-m, 25.8 ft-lb)
T2: 70 N.m (7.1 kgf-m, 51.6 ft-lb)
- Remove the transmission jack.
- Install the heat shield cover. < Refer to INSTALLATION , Heat Shield Cover. >
- Install the center exhaust pipe. (non-turbo model) < Refer to INSTALLATION , Center Exhaust Pipe. >
- Install the center exhaust pipe (rear). (turbo model) < Refer to INSTALLATION , Center Exhaust Pipe. >
- Lower the vehicle.
- Connect the battery ground terminal.