Evaporation Pipe Installation

WARNING: This page is about a different car, the 2013 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Install the evaporation pipe to the vehicle.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Fig 1: Locating Evaporation Pipe Clamp Nut
Courtesy of SUBARU OF AMERICA, INC.
Install the evaporation pipe protector.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Fig 2: Locating Evaporation Pipe Protector Mounting Nuts
Courtesy of SUBARU OF AMERICA, INC.
Install the right side rear quarter trim. < Refer to INSTALLATION , Rear Quarter Trim. >
Connect the evaporation hose.

Fig 3: Locating Evaporation Hose Clamp
Courtesy of SUBARU OF AMERICA, INC.
Install the rear mud guard RH. < Refer to INSTALLATION , Mud Guard. >