LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System (H4DO) >> Water Pump >> Removal >> Water Pump Pulley

Water Pump Pulley

  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G08579605Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the V-belts. Refer to REMOVAL .
  3. Lift up the vehicle.
  4. Remove the under cover. Refer to REMOVAL .
  5. Remove the water pump pulley using the ST.

    ST1 18355AA000 PULLEY WRENCH

    ST2 18334AA030 PULLEY WRENCH PIN SET

    Fig 2: Removing Water Pump Pulley Using ST
    G08563291Courtesy of SUBARU OF AMERICA, INC.