LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Drivelines & Axles >> Wheel Hubs >> Axle Shafts, Propeller Shaft & Hubs >> Front Hub Unit Bearing >> Disassembly

Front Hub Unit Bearing: Disassembly

Using the ST or a hydraulic press, push out the hub bolt (b) from the front hub unit bearing (a).

CAUTION:
  • Be careful not to hammer the hub bolts. This may deform the hub.
  • Do not reuse the hub bolt.

PREPARATION TOOL: 

ST: HUB STAND (28399AG000) 

Fig 1: Pushing Out Hub Bolt Front Hub Unit Bearing Using ST
G07914109Courtesy of SUBARU OF AMERICA, INC.
NOTE: Since the hub unit bearing can not be disassembled, only hub bolts can be removed.
scientia non olet · About LEMON Manuals