LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Legacy Premium, Automatic CVT Trans >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> A/T & M/T Differentials >> Differential Gear Oil >> Replacement

Differential Gear Oil: Replacement

CAUTION:
  • Gear oil is extremely hot just after driving. Be wary of receiving burns.
  • Be careful not to spill the differential gear oil on exhaust pipe. If gear oil is spilled, wipe it off completely.
  1. Lift up the vehicle.
  2. Remove the drain plug and filler plug, and drain the gear oil.
    • T-type
      Fig 1: Identifying Drain Plug And Filler Plug (T-Type)
      G08583059Courtesy of SUBARU OF AMERICA, INC.
    • VA1-type
      Fig 2: Identifying Drain Plug And Filler Plug (VA1-Type)
      G08583060Courtesy of SUBARU OF AMERICA, INC.
    • VA2-type
      Fig 3: Identifying Drain Plug And Filler Plug (VA2-Type)
      G08583061Courtesy of SUBARU OF AMERICA, INC.
  3. Tighten the drain plug.
    NOTE:
    • For the T-type, apply liquid gasket to the drain plug.

    Liquid gasket: 

    THREE BOND 1105 (Part No. 004403010) or equivalent 

    • For VA type, use a new gasket.

    Tightening torque: 

    T-type 

    49 N.m (5.0 kgf-m, 36.1 ft-lb) 

    VA-type: 

    50 N.m (5.1 kgf-m, 36.9 ft-lb) 

  4. Fill the differential carrier with gear oil to the bottom of filler plug.
    NOTE: Carefully refill gear oil while watching the level. Excessive or insufficient oil must be avoided.

    Recommended gear oil: 

    Refer to  SPECIFICATION  . 

    Oil capacity: 

    0.8 L (0.8 US qt, 0.7 Imp qt) 

    • T-type
      Fig 4: Identifying Filler Plug And Drain Plug (T-Type)
      G08583062Courtesy of SUBARU OF AMERICA, INC.
    • VA1-type
      Fig 5: Identifying Filler Plug And Drain Plug (VA1-Type)
      G08583063Courtesy of SUBARU OF AMERICA, INC.
    • VA2-type
      Fig 6: Identifying Filler Plug And Drain Plug (VA2-Type)
      G08583064Courtesy of SUBARU OF AMERICA, INC.
  5. Install the filler plug.
    NOTE:
    • For the T-type, apply liquid gasket to the filler plug.

    Liquid gasket: 

    THREE BOND 1105 (Part No. 004403010) or equivalent 

    • For VA type, use a new gasket.

    Tightening torque: 

    T-type: 

    49 N.m (5.0 kgf-m, 36.1 ft-lb) 

    VA-type: 

    50 N.m (5.1 kgf-m, 36.9 ft-lb)