Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK POWER SUPPLY FOR STEERING ANGLE SENSOR. Turn the ignition switch to OFF. Disconnect the connector from steering angle sensor. Turn the ignition switch to ON. Measure the voltage between steering angle sensor and chassis ground. Connector & terminal (B231) No. 4 (+) - Chassis ground (-):	Is the voltage 10 - 15 V?	Go to step 2 .	Repair the steering angle sensor power supply circuit.
2 CHECK GROUND CIRCUIT OF STEERING ANGLE SENSOR. Measure the resistance between steering angle sensor and chassis ground. Connector & terminal (B231) No. 1 - Chassis ground:	Is the resistance less than 10 Ω?	Go to step 3 .	Repair ground circuit in the steering angle sensor.
3 CHECK STEERING ANGLE SENSOR. Turn the ignition switch to OFF. Connect all connectors. Clear the memory. < Refer to CLEAR MEMORY MODE . > Perform the Inspection Mode. < Refer to INSPECTION MODE . > Read the DTC.	Is the same DTC displayed?	Go to step 4 .	Go to step 5 .
4 CHECK VDCCM&H/U. Turn the ignition switch to OFF. Replace the steering angle sensor. < Refer to STEERING ANGLE SENSOR . > Clear the memory. < Refer to CLEAR MEMORY MODE . > Perform the Inspection Mode. < Refer to INSPECTION MODE . > Read the DTC.	Is the same DTC displayed?	Replace the VDCCM&H/U. < Refer to VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM&H/U) . >	Go to step 6 .
5 CHECK OTHER DTC DETECTION.	Is any other DTC displayed?	Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >	Temporary poor contact occurs. Though VDC warning light may remain lit, this is normal. Warning light goes off when the vehicle is driven at 12 km/h (7 MPH) or more.
6 CHECK OTHER DTC DETECTION.	Is any other DTC displayed?	Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >	Original steering angle sensor malfunction