Hill Hold Indicator Light Do Not Go Off: Trouble Symptom
When starting the engine, the hill hold indicator light remains lit.
| Step | Check | Yes | No |
|---|---|---|---|
| 1 READ DTC. Read the DTC. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . > |
Is DTC displayed? | Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > | Go to step 2 . |
| 2 CHECK LAN SYSTEM. Check the DTC in LAN system. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . > |
Is DTC of LAN system displayed? | Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . > | Go to step 3 . |
| 3 CHECK ELECTRONIC PARKING BRAKE CM. With the engine started, display the current data of the electronic parking brake CM using Subaru Select Monitor. |
When the hill hold switch is not operated after starting the engine, is the «Hill hold lamp» ON? | Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . > | Go to step 4 . |
| 4 CHECK COMBINATION METER. Check the combination meter. < Refer to SELF-DIAGNOSIS DISPLAY MODE , OPERATION, Combination Meter System. > |
Is combination meter OK? | Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . > | Replace the combination meter. < Refer to COMBINATION METER . > |