Parking Brake Removal Mode

CAUTION:

Subaru Select Monitor is required for the parking brake removal mode.
Make sure to perform this procedure with the vehicle lifted.
When this mode is performed by mistake, operate and then release the parking brake.

NOTE: When disassembling the parking brake, use this function to set the parking brake cable at the release position.

Lift up the vehicle.
Connect the Subaru Select Monitor.
On «Main Menu» display, select {Each System Check}.
On «System Selection Menu» display, select {Brake Control System}.
Click the [OK] button after {Parking Brake System} is displayed.
On «Maintenance Operation Mode» display, select {Parking Brake Removal Mode}.
The confirmation screen, "Perform parking brake removal?", is displayed. Click the [YES] button.
The message, "Releasing parking cable until removal position.", is displayed on the screen, and the removal mode begins.
The message, "Parking cable released until removal position.", is displayed on the screen. Turn the ignition switch to OFF to end the removal mode.