- Electronic parking brake warning light illuminates. (C6 model)
- Brake warning light blinks. (Models other than C6 model)
|
Parking brake system does not operate. |
- Defective parking brake switch
- Defective electronic parking brake control module
- Defective power supply/ground for electronic parking brake control module
- No CAN signal received from VDC control module
- Defective actuator in the electronic parking brake control module
- Defective force sensor in the electronic parking brake control module
- Defective temperature sensor in the electronic parking brake control module
- Defective stroke sensor in the electronic parking brake control module
- Defective CAN communication
|
- Electronic parking brake warning light illuminates. (C6 model)
- Brake warning light blinks. (Models other than C6 model)
|
Hill hold function and accelerator interlocking release function do not operate. |
- Defective hill hold switch
- Faulty signal received from engine control module
- Faulty signal received from transmission control module
- Faulty signal received from VDC control module
- Defective neutral position switch (MT model only)
- Defective back-up light switch (MT model only)
- Defective parameter selection for the electronic parking brake control module
- No CAN signal received from engine control module
- No CAN signal received from transmission control module
- No CAN signal received from body integrated unit
- Defective clutch stroke sensor (MT model only)
- Defective longitudinal G sensor
|
| The brake warning light blinks, and the electronic parking brake warning light (C6 model only) and hill hold indicator light illuminate. |
- |
No CAN signal from the electronic parking brake control module to combination meter |
| EyeSight does not operate. |
- |
- Faulty signal received from stereo camera
- No CAN signal received from stereo camera
- No CAN signal received from combination meter
|
| Only the brake warning light blinks. |
- |
- Mid-course stop state
- Emergency release state
- The operation and release of the parking brake was repeated excessively
|
| The brake warning light blinks, and the electronic parking brake warning light (C6 model only) illuminates. |
Parking brake system does not operate. |
Parking brake shoe clearance too large |
| When the hill hold function is set to ON, drugging of brake may occur when the vehicle starts to move. |
- |
Driver's seat belt is not fastened. |
| Noise emitted from the parking brake cable when applying/releasing the parking brake. |
- |
Deterioration has occurred inside the cable due to improper assembly of the parking brake cable. |