Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 INTERVIEW CUSTOMERS. Ask the user if emergency release was performed.	Was the emergency release performed?	Go to step 2 .	Go to step 3 .
2 CHECK ELECTRONIC PARKING BRAKE CM. Turn the ignition switch to ON, and then release the parking brake. After approximately 10 seconds, clear the memory using the Subaru Select Monitor. < Refer to CLEAR MEMORY MODE . > Perform the Inspection Mode. < Refer to INSPECTION MODE . > Read the DTC.	Is DTC displayed?	Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >	End.
3 CHECK PARKING BRAKE ASSEMBLY. Check that the parking brake assembly does not have malfunction. < Refer to INSPECTION , Emergency Release of Electronic Parking Brake. >	Is the parking brake assembly free of malfunction?	Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . >	Repair the parking brake assembly.