Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK PARKING BRAKE ASSEMBLY. Check the parking brake cable connection of parking brake assembly.	Is there any trouble with the parking brake shoe lever or the parking brake cable connection?	Repair the parking brake cable connection. Go to step 2 .	Go to step 2 .
2 CHECK PARKING BRAKE ASSEMBLY. Check the parking brake assembly disc rotor and shoe assembly. < Refer to INSPECTION , Parking Brake Assembly (Rear Disc Brake). >	Are the disc rotor and shoe assembly normal?	Adjust the shoe clearance of the parking brake assembly. < Refer to ADJUSTMENT , Parking Brake Assembly (Rear Disc Brake). > Go to step 3 .	Replace the defective parts, and adjust the shoe clearance of the parking brake assembly. < Refer to ADJUSTMENT , Parking Brake Assembly (Rear Disc Brake). > Go to step 3 .
3 PERFORM CALIBRATION OF FORCE SENSOR USING SUBARU SELECT MONITOR. Perform calibration of force sensor using the Subaru Select Monitor. < Refer to FORCE SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor. > Clear the memory. < Refer to CLEAR MEMORY MODE . > Read the DTC.	Is the same DTC displayed?	Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . >	It results from poor adjustment of the shoe clearance.