Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK ECM, TCM AND COMBINATION METER. Check that ECM, TCM and combination meter with correct specifications are installed.	Are correct ECM, TCM and combination meter installed?	Go to step 2 .	Replace with parts with correct specifications.
2 INITIALIZE PARAMETER USING SUBARU SELECT MONITOR. Using the Subaru Select Monitor, initialize the parameter for the electronic parking brake CM. < Refer to PARAMETER INITIALIZATION MODE , OPERATION, Subaru Select Monitor. > Perform calibration of the force sensor. < Refer to FORCE SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor. > Perform calibration of the clutch sensor. < Refer to CLUTCH SENSOR CALIBRATION MODE , OPERATION, Subaru Select Monitor. > Clear the memory. < Refer to CLEAR MEMORY MODE . > Read the DTC.	Is the same DTC displayed?	Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . >	It results from a temporary noise interference.