Diagnostic Procedure

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK OUTPUT OF NEUTRAL POSITION SWITCH USING SUBARU SELECT MONITOR. Select "Current Data Display & Save" for "Engine Control System" on Subaru Select Monitor. < Refer to SUBARU SELECT MONITOR . > < Refer to SUBARU SELECT MONITOR . > Read the «Neutral switch» output displayed on the screen.	Is "Neutral" displayed on the screen at neutral state?	Go to step 2 .	Perform the diagnosis for the engine. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . > < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . >
2 CHECK OUTPUT OF BACK-UP LIGHT SWITCH USING SUBARU SELECT MONITOR. Select "Current Data Display & Save" for "Integ. unit mode" on Subaru Select Monitor. < Refer to READ CURRENT DATA . > Read the «MT Reverse Switch» output displayed on the screen.	Is "ON" displayed on the screen at reverse state?	Go to step 3 .	Check DTC of integrated unit. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . >
3 CHECK LAN SYSTEM. Check the DTC in LAN system. < Refer to READ DIAGNOSTIC TROUBLE CODE (DTC) . >	Is DTC of LAN system displayed?	Perform the diagnosis according to DTC. < Refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >	Go to step 4 .
4 CHECK ELECTRONIC PARKING BRAKE CM. Clear the memory. < Refer to CLEAR MEMORY MODE . > Perform the Inspection Mode. < Refer to INSPECTION MODE . > Read the DTC.	Is the same DTC displayed?	Replace the electronic parking brake CM. < Refer to PARKING BRAKE ACTUATOR . >	Go to step 5 .
5 CHECK OTHER DTC DETECTION.	Is any other DTC displayed?	Perform the diagnosis according to DTC.	It results from a temporary poor contact interference.