Rear Brake Hose
- Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.
- Insert the clamp to secure brake hose.
Tightening torque:
Brake hose bracket: 33 N.m (3.36 kgf-m, 24.3 ft-lb)
- Install the brake hose to rear caliper body using a new gasket.
Tightening torque:
Union bolt: 18 N.m (1.84 kgf-m, 13.3 ft-lb)
- Tighten the flare nut to the specified torque.
Tightening torque:
Brake pipe flare nut: 15 N.m (1.53 kgf-m, 11.1 ft-lb)
- Bleed air from the brake system. Refer to PROCEDURE .